Distortion..Good or bad? Why not both?
There are many types of Distortion caused by different things and get very different sounds. Those types are analog distortion, digital distortion, compression distortion and microphone distortion. I will talk about these more throughout this blog.
Being an Audio Engineer in training, I need to know how distortion effects the signal whether I can use it to my advantage or it will hinder my sound and I will need to correct my way of mixing or my way of recording.
The way I will be showing you is through creating a sine wave in Protools using a signal generator at 1Khz and the level at -20.0Db. I then ran this signal through a spectrum analyser to show that it is truly 1khz and by nature and the settings inputted it has no harmonic content. Liam White and I completed this task together utilising the neve studio which I will discuss later.
Here is the sound clip for the sine wave(Original)


Digital Distortion
Digital distortion is when a signal is passed through a DAW such as Protools, Logic or Ableton and when the signal is boosted too high clipping begins to occur. The way I showed how digital distortion affected my original signal was to get the original sine wave mentioned and then boost the level. I also added a gain plugin to further boost the signal.
As you can hear by the distorted signal, its much harsher and obviously louder. Unlike with analog distortion which will be much smoother in comparison. Digital clipping is very noticeable and not a nice tone by any means.
The frequency of the distorted signal has much more low end from the previous sine wave. You can’t tell from this screenshot, but the frequency Db. levels fluctuate for example it fluctuates in db level at around 15Hz-470Hz, audibly you can also tell that this signal is very muddy. This is where distortion can be a bad thing opposed to analog distortion being a relatively good method.

This is the digital distortion link
Analogue Distortion
Analogue distortion is caused when a signal is passed through an analogue mixing desk at a level that causes the desk to ‘clip’ that signal. To demonstrate this we took that original sine wave into the NEVE studio and ran it through the desk and boosted the level till it started to distort. We then re-recorded it back into protools. We thought why not do it another 2 times for a total of 3 times to fully get a distorted sound. The result was the absolute rubbish sine wave that is more in the form of a square wave now. But we found that analogue distortion is much smoother and more enjoyable
Here is the final distortion(After three times of running it through)
As you can see by the spectrum analyser below. There is so much more harmonics, as well as a few odd harmonics .The frequency is very sporadic with more movement from 400Hz- 22Khz. This is such a drastic change from the original since wave has there is so much more high end frequencies and as mentioned before is changing more into a square wave.

Microphone Distortion
For this part of Distortion, we decided to mic up a snare drum and overload the preamp and thus distorting the microphone. Creating distortion through a microphone signal is one of the easiest ways to understand and perform distortion. As the performer was playing the snare drum we gradually increased the level till it was distorted as the preamp would allow.
Here is the end result.

As you can see there is a lot of mid range information that is pretty common with snare drums, but because we distorted it along the way this screenshot is mid way through the sample. Distorting the microphone throughout the sample gave us more a distorted sound and from 1khz-20khz the frequencies were sporadic.
Compression Distortion
Compressional distortion occurs when you ‘squash’ a signal and turn the output straight up on a compressor to demonstrate this we used the same snare sample and ran it through a compressor plug-in. We chose a plug-in instead of an outboard compressor for the variety of compressor plug-ins, the ease of use. This form of distortion had the least amount of difference but there is slight audible change and represented the analogue distortion sound we tested earlier.

Gathering from the spectral analyzer I found that the mid frequencies were boosted in this sample. However the same harmonics were present in this form of distortion as well as the previous distortion; microphone distortion.
I really enjoyed doing this LO. I became aware of the different types of distortion and got a better understanding of what they sound like across a variety of platforms.
This task addresses these LO’s
2, 16, 21, 17